Dr. Ignacio Alejandro Figueroa Vargas
Investigador Titular " C " T.C.
PRIDE: " D "
SNI: III
PRIDE: " D "
SNI: III
FORMACIÓN PROFESIONAL
- Ingeniero en Materiales, Instituto Técnologico de Morelia (Especialidad en Metalurgia del Hierro y Acero)
- Maestría en Metalurgia y Ciencias de los Materiales, IIMM-UMSNH
- PhD Materials Science and Engineering (Metallurgy), University of Sheffield, UK
- Research Fellow, Advanced Manufacturing Research Centre with Boeing, Rolls-Royce Factory of the Future, Catcliffe, UK
LINEAS DE INVESTIGACIÓN
- Aleaciones fuera del equilibrio
- Solidificación rápida
- Vidrios metálicos convencionales y en bulto
- Aleaciones nanocristalinas
- Espumas metálicas
ÚLTIMAS PUBLICACIONES
Effect of Small Additions of Cr, Ti, and Mn on the Microstructure and Hardness of Al–Si–Fe–X Alloys
V.A. Aranda, I.A. Figueroa, González, G., J.A. García-Hinojosa, G.A. Lara-Rodríguez.
Metals. 9-2 (2019), 136-150.
Determination of Chemical, Composition of Compounds in Lead-Free Solder Alloy Sn-Zn-Al Using SEM/EDS.
IA Figueroa, O Novelo-Peralta, GA Lara-Rodríguez,
Metallography, Microstructure, and Analysis. 9-4 (2020) 570-575
Study of the microstructure and mechanical properties of Al-Si-Fe with additions of chromium by suction casting.
V. A. Aranda, I. A. Figueroa, G. González, J. A. García-Hinojosa, I. Alfonso.
Journal of Alloys and Compounds. 853-5 (2021) 157155.
Mechanical behavior of heat-treated Al-Cu-Mg open-cell foams.
I. A. Figueroa, I. Mendieta, M. F. Azamar, G. A. Lara-Rodríguez, O. Novelo-Peralta,
Materials Letters. 284-1 (2021) 129021.
Microstructural and Mechanical Analysis of an 1100 Aluminum Alloy Processed by Repetitive Corrugation and Straightening.
E.E., Alvarado, I.A. Figueroa, G. Gonzalez,
Phys. Metals Metallogr. 121 (2021) 1319–1325